INSTALLATION PRECAUTIONS  

1. After installation, let the water keep flowing for about 15 minutes or at least 25 Lt. to remove the remaining carbon powder and filter’s glue. If the water still tastes bitter then leave it flowing until it turns to be sweet taste.

2. Too low water pressure makes the water flow little. Suggesting the flowing speed to be over 1.6 LPM (1.6Lt. per min.) Please refer to the figure on the flowmeter on top of the machine.

3. Remember to put the batteries into the battery boxes for flowmeter and far infrared sensor.  The specifications are as below:

     a. Flowmeter -- 2pcs of AAA battery

     b. Far infrared sensor -- 4pcs of AA battery 

4. If out of home or not to use filter for a long time, we suggest to switch the far infrared sensor box off to save the energy and water consumption.

5. The velcro is attached at the bottom of the far infrared sensor box. Stick the velcro in place and take off the battery box when it comes to change the battery and put it back after              done.

6. The instruction for electronic flowmeter is inside the case.  Please follow the directions to set up the Liter number to change the filters.  Suggestions for each filter is as below. 

    Cartridge (1): 1000 Lt.

    Cartridge (2): 1000 Lt.   

    Cartridge (3): 2000 Lt.

    Cartridge (4): 4000 Lt. 

    Cartridge (5): 1000 Lt.

    Cartridge (6): 4000 Lt.

* The intervals to change the cartridge are different following the water quality in each area.  You may adjust according to the local water quality.

* If the local water pressure is not enough, the cartridge hollow fiber membrane filter easily accumulate air and result in little flowing water. Please call Hiend after-service immediately for further treatment. 

7. When open or close the front/back panels of the case, please open powerfully and push down heavily. Due to tightness of the latch, it’s normal if the sound is very loud when closing or opening the panels.

8. On changing the cartridge, please hold the cartridge turning clockwise and then take off downwards. On installing the cartridge, please let the front side (sticked label) towards left and push upward to the head, then hold the cartridge turning counter-clockwise to tighten it. The cartridge’s label should face to outside and in accordance with the small round sticker with number on the black head of the cartridge.

Attentions :   (1) Before changing the cartridge, remember to close the water supply

                     (2)The bigger air-leaking sound is normal when changing cartridge

9. To ensure the proper use, we suggest the filter to be installed by Hiend technician or the technician approved by the agents.

10. The Hydrogen Water Filter would probably need to change the filters earlier because of the odor smell concerning the water quality or less use . 

Hiend Negative Hydrogen Water Filter’s Specification Chart

Web: www.mytopwater.com

Tel:  04-23200538

Working hour: Monday thru Friday AM9:00 –PM6:00 (Break time12:00 –PM1:00)

Mailbox: chiangyuan888@gmail.com

Franchise:Home Water Purifier / filter / patented filtersome Water Purifier / filter / patented filters

Hiend ,The new source , Negative hydrogen water , Water element water , Hydrogen water , Hydrogen-enriched water , Oxidation resistance , Anti-aging , Negative hydrogen ions , Negative hydrogen water health Cup , Water element Builder , Green laundry ball , In addition to chlorine shower , Water Pass , Water Purifier , Water filter, Energy water , Negative ion water, small molecule water, environmental hormones,top Water, dissolved oxygen in the water, oxygenated water, water dispenser, reverse osmosis, fountain of the Institute , bottled water, Water Ionizer, alkaline water, filter , filter